the user to the presence of | CAUTION | user to the presence of important | |
This symbol is intended to alert |
|
| This symbol is intended to alert the |
uninsulated “dangerous voltage” | RISK OF ELECTRIC SHOCK | operating and maintenance (servic- | |
within the product’s enclosure | DO NOT OPEN |
| ing) instructions in the literature |
that may be of sufficient mag- |
|
| accompanying the appliance. |
nitude to constitute a risk of |
|
|
|
electric shock to persons. |
|
|
|
THIS UNIT CONTAINS HIGH VOLTAGE INSIDE! | REFER SERVICING TO A QUALIFIED TECHNICIAN | ||
IMPORTANT! FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:
WATER AND MOISTURE: Do not expose this appliance to rain or moisture. Do not use this apparatus near water (in a wet basement, near a swimming pool, bathtub etc). Care should be taken so that liquids are not spilled or splashed onto the unit. Do not place objects filled with liquids such as beverage containers on this apparatus.
POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instruc- tions or as marked on the unit. Unplug during lightning storms.
GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.
POWER CORD: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs and the point where they exit from the appliance. The plug or power inlet is the disconnect device and shall remain readily operable.
PLACEMENT: Do not block ventilation openings. Do not install near heat sources such as radiators, stoves or other products that produce heat. Do not install in a confined area. Use only mounting hardware such as brackets and tripods recommended by the manufacturer.
SERVICING: The user should not attempt to service the unit. All servicing should be referred to qualified service personnel.
FUSING: If your unit is equipped with a fuse receptacle, replace only with the same type fuse. Refer to replacement text on the unit for correct fuse type.
LIMITED WARRANTY
Your Carvin product is guaranteed against failure for 3 YEARS unless otherwise stated. Carvin will service and supply all parts at no charge to the customer providing the unit is under warranty. Shipping costs are the responsibility of the customer. CARVIN DOES NOT PAY FOR PARTS OR SERVICING OTHER THAN OUR OWN. A COPY OF THE ORIGINAL INVOICE IS REQUIRED TO VERIFY YOUR WARRANTY. This warranty does not cover, and no liability is assumed, for damage due to: natural disasters, accidents, abuse, loss of parts, lack of reasonable care, incorrect use, or failure to follow instructions. This warranty is in lieu of all other warranties, expressed or implied. No representative or person is authorized to represent or assume for Carvin any liability in connection with the sale or servicing of Carvin products. CARVIN SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
When RETURNING merchandise to the factory, you must call for a return authorization number. If your unit is out of warranty, you will be charged the current FLAT RATE for parts and labor to bring your unit up to factory specifications.
HELP SECTION
1)UNIT WILL NOT TURN ON: Check the power to the AC cord. Check for tripped circuit breakers, unplugged extension cords or
2)NO OUTPUT with POWER light ON: Shipping damage will be the primary reason for your product to not function properly. Please give us a call to help you determine the problem.
3)KEEP YOUR UNIT LOOKING NEW: Use only a dry cloth to wipe the control and venting areas. Surfaces without openings may be cleaned with a damp cloth.
2-way SystemS Specs:
| LS1002 |
| LS1202 | LS1502 / 1502A |
Frequency Response +/- 3dB | 85Hz - 20kHz (72Hz - 10dB) | Frequency Response +/- 3dB | 76Hz - 18kHz (70Hz - 10dB) | 53Hz - 18kHz 47Hz - 10dB) / 350w |
|
|
|
| RMS (Hi Freq: 50w @ 16 ohms, Lo |
|
|
|
| Freq. 300w @ 8 ohms) |
Power Capacity | 200 W continuous, 400 W peak | Power Capacity | 300 W continuous, 600 W peak | 400 W continuous, 800 W peak |
Sensitivity | 98 dB SPL, 1W / 1M | Sensitivity | 97 dB SPL, 1W / 1M | 100 dB SPL, 1W / 1M |
Calculated Max SPL | 124 dB | Calculated Max SPL | 125 dB | 129 dB |
Nominal Directivity | 60 degrees HxV | Nominal Directivity | 90 degrees HxV | 90 degrees HxV |
Nominal Impedance | 8 Ohms | Nominal Impedance | 8 Ohms | 8 Ohms |
Enclosure Type | Vented Bass Reflex | BiAmp Impedance | LF 8 Ohms, HF 16 Ohms | LF 8 Ohms, HF 16 Ohms |
Enclosure Construction | 12mm Baltic birch cross grain | Enclosure Type | Vented Bass Reflex | Vented Bass Reflex |
| laminated plywood |
|
|
|
Recommended Power Amp | 200 W - 400W | Enclosure Construction | 12mm Baltic birch cross grain | 12mm Baltic birch cross grain |
|
|
| laminated plywood | laminated plywood |
Dimensions | 12.4”W x 11”D x 18”H | Recommended Power Amp | 300 W - 600W | 400 W - 800W |
Weight | 23 lbs. | Dimensions | 15”W x 13.2”D x 24.5”H | 18”W x 14”D x 27.5”H |
|
| Weight | 33 lbs. | 43 lbs. |
| LS1503/1503A | LS1523 / 1523A | LS2153 |
Frequency Response +/- 3dB | 52Hz - 20kHz (46Hz - 10dB) / 425w | 51Hz - 20kHz (45Hz - 10dB) / | 51Hz - 20kHz (45Hz - 10dB) |
| RMS (Hi Freq: 50w @ 16ohms, Mid | 900w RMS (Hi Freq: 80w @ 16 |
|
| Freq: 75w @ 16 ohms, Lo Freq. 300w | ohms, Mid Freq: 120w @ 8 ohms, |
|
| @ 8 ohms) |
| |
| Lo Freq. 700w @ 4 ohms) |
| |
|
|
| |
Power Capacity | 400 W continuous, 800 W peak | 800 W continuous, 1600 W peak | 800 W continuous, 1600 W peak |
Sensitivity | 101 dB SPL, 1W / 1M | 101 dB SPL, 1W / 1M | 101 dB SPL, 1W / 1M |
Calculated Max SPL | 130 dB | 133 dB | 133 dB |
Nominal Directivity | 90 degrees H x 60 degrees V | 90 degrees H x 60 degrees V | 90 degrees H x 60 degrees V |
Nominal Impedance | 8 Ohms | 4 Ohms | 4 Ohms |
BiAmp Impedance | LF 8 Ohms, MF/HF 8 Ohms | LF 8 Ohms, MF/HF 8 Ohms | LF 8 Ohms, MF/HF 8 Ohms |
Enclosure Type | Vented Bass Reflex | Vented Bass Reflex | Vented Bass Reflex |
Enclosure Construction | 12mm Baltic birch cross grain | 12mm Baltic birch cross grain | 12mm Baltic birch cross grain |
| laminated plywood | laminated plywood | laminated plywood |
Recommended Power Amp | 400 W - 800W | 800 W - 1600W | 800 W - 1600W |
Dimensions | 18.75”W x 15.5”D x 24”H | 22..5”W x 19.75”D x 46.75”H | 16.5”W x 14.75”D x 43.75”H |
Weight | 58 lbs. | 105 lbs. | 71 lbs. |
SUBWOOFER SYSTEMS:
| LS1801 / 1801A | LS1802 | LS1802 |
Frequency Response +/- 3dB | 35Hz - 150Hz (29Hz - 10dB) / 700w | 30Hz - 150Hz (24Hz - 10dB) | 30Hz - 150Hz (24Hz - 10dB) |
| RMS @ 4 ohms |
|
|
Power Capacity | 800 W continuous, 1600 W peak | 1600 W continuous, 3200 W | 1600 W continuous, 3200 W peak |
|
| peak |
|
Sensitivity | 98 dB SPL, 1W / 1M | 102 dB SPL, 1W / 1M | 102 dB SPL, 1W / 1M |
Calculated Max SPL | 130 dB | 137 dB | 137 dB |
Nominal Directivity | N/A | N/A | N/A |
Nominal Impedance | 4 Ohms | 4 Ohms | 4 Ohms |
Enclosure Type | Vented Bass Reflex | Vented Bass Reflex | Vented Bass Reflex |
Enclosure Construction | 12mm Baltic birch cross grain | 12mm Baltic birch cross grain | 12mm Baltic birch cross grain |
| laminated plywood | laminated plywood | laminated plywood |
Recommended Power Amp | 800 W - 1600W | 1600 W - 3200W | 1600 W - 3200W |
Dimensions | 19.5”W x 22”D x 23.5”H | 39.5”W x 22”D x 23.5”H | 39.5”W x 22”D x 23.5”H |
Weight | 71 lbs. | 119 lbs. | 119 lbs. |
The power generated by the APS internal power amps has the capacity to damage the drivers, in which case they would not be covered under warranty.
