Cary Audio Design SLI-80 CHARTS AND DRAWINGS ,

CHARTS AND DRAWINGS

Bias Adjustment

Set bias for both sides of the amplifier to 75mA.

 Insert meter plug into bias jack.

 Adjust for 7mA reading on DC current meter.

 Re-adjust to 75mA after SLI 80 is warmed up for 10 minutes.

 Remove plug and enjoy the music!

Note: Bias is factory preset; Bias should be reset when installing replacement KT-88 / 6550 tubes.

Bias Meter Jack Bias Adjust

Contents

Main OWNERS MANUAL SLI-80 Integrated Stereo Amplier TABLE OF CONTENTS Page IMPORTANT SAFETY INSTRUCTIONS INTRODUCTION (not cheap voltage doublers used in many amplifiers) Page SPECIFICATIONS . (additional charge) FEATURES INSTALLATION OPERATION SERVICE AND CARE TROUBLESHOOTING GUIDE (See Bias Adjustment, p 11) CHARTS AND DRAWINGS CHARTS AND DRAWINGS