Operation Guide 4312/4313

Setting the Analog Time Manually

You can use the Hand Setting Mode to adjust the analog time manually when it does not match the digital time.

Getting Ready:

Use the C button to enter the Hand Setting Mode as shown under “Modes and Display Screens”.

1. Hold down the Abutton for about two seconds until the hour and minutes of the digital time start to flash.

2. Use the D button to adjust the analog time.

Each press of the Dbutton advances the analog time by 20 seconds.

Holding down the Dbutton advances the time setting at high speed.

High-speed Lock

While holding down the Dbutton to start high-speed clockwise movement of the hands, press the B button to lock the high- speed movement.

High-speed movement of the hands will continue until it completes a 12-hour cycle, or until you press any button to stop it.

High-speed hand movement will stop when an alarm or any other beeper operation is performed. Hand movement will resume after the beeper operation is complete.

3. When the setting is the way you want, press the A button to exit the setting screen.

This exits the setting screen and synchronizes the minute hand with the current seconds count automatically.

The display also will exit the setting screen automatically if you do not perform any operation for about two or three minutes.

7