A P P E N D I X B
Connector and Cable Specifications
Revised: January 12, 2012
This appendix describes the Cisco ME 4924-10GE switch ports and the cables and adapters that you use to connect the switch to other devices.
Connector Specifications
These sections describe the connectors used with the switch.
Connecting to 1000BASE-T Devices
When connecting the ports to 1000BASE-T devices, such as servers, workstations, and routers, you must use a four-twisted-pair, Category 5, straight-through cable wired for 10BASE-T, 100BASE-TX, and 1000BASE-T.
When connecting the ports to other devices, such as switches or repeaters, you must use a four-twisted-pair, Category 5, crossover cable. Be sure to use a four-twisted-pair, Category 5 cable when connecting to a 1000BASE-T-compatible device.
Note Use a straight-through cable to connect two ports only when one port is designated with an X. Use a crossover cable to connect two ports when both ports are designated with an X or when both ports do not have an X.
SFP Module Ports
The Cisco ME 4924-10GE switch uses SFP modules for fiber-optic and copper uplink ports. Refer to the Cisco ME 4924-10GE switch release notes for a list of supported SFP modules.
Figure B-1 Fiber-Optic LC Connector
| 58476 |
| Cisco ME 4924-10GE Ethernet Switch Hardware Installation Guide |
OL-10071-01 | B-1 |
