Getting Ready 
4. Use the two screws I to secure the top left and right edges of the back panel C to the brackets 5 of side panels A and B.
•At location 6, slip the clip G onto to the screw I before installing the screw.
| B | 5 |
6 |
| |
| A | |
|
| |
G |
|
|
I
I
5.Next, secure the bottom of the back panel C with the six F screws.
•Place one of the clips G onto the leftmost screw F as shown in the illustration below.
B 
A
C
G 
F
6. Adjust the height adjustment screw 7 to provide support so crosspiece D does not bow downwards when the pedals are pressed.
D7
IMPORTANT!
•Pressing the pedals without adjusting height adjustment screw 7 can result in damage to crosspiece D. Always make sure you adjust height adjustment screw 7 before operating the pedals.
7. Place the piano onto the stand.
IMPORTANT!
•In order to ensure you do not get your fingers pinched between the piano and the stand, grasp the
piano on its sides (not its ends) at the locations marked with stars () in the illustration.
At least 10cm
At least 10cm
9
•At this time the screws on the bottom of the piano 8 should hook into the cutouts in the stand brackets 9.
Back of piano
Bracket cutout
9 | Stand side panel |
|
8
English