Casio CTK-3000, CTK-2000 Using the 10-keyPad (bn), Using the Setting Button (3), Number Buttons, [–]and [+] Buttons, 1.Press, Display, See Page, Parameter, Next press, General Guide

General Guide

Using the 10-key Pad (bn)

Use the number buttons and the [–] and [+] buttons to change the settings of the parameters that appear in the upper left area of the display.

Setting

M d e r n P n o

Number Buttons

Use the number buttons to enter numbers and values.

•Enter the same number of digits as the currently displayed value.

Example: To enter tone number 005, input 0 3 0 3 5.

•Negative values cannot be input using the number buttons. Use [+] (increase) and [–] (decrease) instead.

[–]and [+] Buttons

You can use the [+] (increase) and [–] (decrease) buttons to change the displayed number or value.

•Holding down either button scrolls the displayed setting.

•Pressing both buttons at the same time will revert to the initial default setting or the recommended setting.

Using the Setting Button (3)

Use the Setting button (3) to access settings that let you select the reverb type, pedal effect, etc.

1.Press 3.

Setting

T r a n s .

Parameter

2.Next press 3 until the parameter whose setting you want to change is displayed.

Each press of 3 cycles through the available parameters.

	Parameter	Display	See Page
1	Transpose	Trans.	E-11
2	Accompaniment Volume	AcompVol	E-31
3	Song Volume	Song Vol	E-17
4	Touch Response	Touch	E-7
	(CTK-3000 only)
5	Tuning	Tune	E-11
6	Reverb	Reverb	E-10
7	Voice Fingering Guide	Speak	E-22
8	Note Guide	NoteGuid	E-23
9	Performance Evaluation	Scoring	E-23
10	Phrase	PhraseLn	E-23
11	Sampling Start	SmplAuto	E-13
12	Keyboard Channel	Keybd Ch	E-33
13	Navigate Channels	Navi. Ch	E-33
14	Local Control	Local	E-34
15	Accomp Out	AcompOut	E-34
16	Pedal Effect	Jack	E-10
17	Pitch Bend Range	Bend Rng	E-11
	(CTK-3000 only)

3.When the parameter you want is displayed, use bn (10-key) to change its setting.

•The parameter setting will disappear from the upper left area of the screen if you do not perform any operation for some time.

•The tone and other parameters revert to their initial defaults whenever you turn on power (page E-6).

E-4