Operation Guide DQR-100U

•To clear the high temperature and low temperature data memory, press the CLEAR button (8). New data starts to be stored after memory is cleared.

CLEAR button (8)

USING THE SUB-UNIT

Data Transfer from the Sub-unit

•Data is transferred from the sub-unit to the main unit every three minutes.

•The sub-unit is able to send data to the main unit up to an unobstructed distance of about 30 meters.

•The data receive status is indicated on the display of the main unit by the icons shown below.

Receive successful

Receive unsuccessful

•If a receive operation is not successful for some reason, the display of the main unit shows dashes (–) in place of the sub-unit temperature value.

•If you experience problems with data transfer, press the RE-SYNC button (0) to synchronize the two units. If this does not eliminate the problem, try changing the positions or orientations of the main unit and sub-unit.

Switching between Celsius and Fahrenheit

•Push the °C/ °F button (A) to toggle between Celsius (°C) and Fahrenheit (°F).

Celsius (°C)

Fahrenheit (°F)

°C/ °F button (A)

Location

•Place the sub-unit in a location where it will not be exposed to rain, direct sunlight, or other elements.

MAIN UNIT/SUB UNIT COMMUNICATION PRECAUTIONS

Sub Unit Location

•Certain environmental conditions can greatly reduce the communication range.

•Avoid the following locations for the sub-unit.

Inside, among

Inside a vehicle

Near refrigerators

Near a

Near high-tension

buildings, or near

 

or other household

construction site,

power lines

neon signs

 

appliances, near

airport, or other

 

 

 

office equipment,

sources of

 

 

 

mobile phones or

electrical noise,

 

 

 

wireless LAN

underground or in

 

 

 

devices.

tunnels, near

 

 

 

 

railroads,

 

 

 

 

highways, or radio

 

 

 

 

stations with

 

 

 

 

interfering

 

 

 

 

frequencies.

 

•Locating the sub-unit near a device that transmits radio signals using the same frequency as this product can cause communication failure of this product.

•Avoid using multiple products in the same area. Doing so can cause mixing of their signals.

RADIO, EMC AND SAFETY REGULATIONS

This product complies with technical specifications required under EN 301 489-3,EN 300-220-3 and EN 60950.

5