GETTING READY

3.Turn off the camera.

IMPORTANT!

4.Set the camera onto the USB cradle.

•Do not place the camera onto the USB cradle while it is turned on.

•The [CHARGE] lamp on the USB cradle should turn red, indicating that charging has started. When charging is complete, the [CHARGE] lamp will turn green.

PLAY

REC

MENU

SET

DISP

PHOTO

CHARGE

 

 

USB

 

 

[CHARGE] lamp

• It takes about two hours to achieve a full charge.

Actual charging time depends on current battery

capacity and charging conditions.

• Use only the USB cradle (CA-21A) that comes with

the camera, the optionally available USB cradle (CA-

21), or the optionally available charger unit (BC-10L)

to charge the special NP-20 rechargeable lithium ion

battery. Never use any other charging device.

• Use only the bundled AC adaptor. Never use any

other type of AC adaptor. Do not use optionally

available AD-C40, AD-C620 and AD-C630 AC

adaptors with this camera.

• Make sure that the camera connector of the USB

cradle is securely inserted into the camera’s

connector as far as it will go.

• The [CHARGE] lamp may remain amber colored and

5.After charging is complete, remove the camera from the USB cradle.

the charge operation may not start right away if you

try to charge immediately after using the camera

(which causes battery to become warm) or when it is

too hot or too cold where you are performing the

charge operation. If this happens, simply wait until

the battery reaches normal temperature. The

[CHARGE] lamp will turn red and charging will start

when the battery temperature returns to the

allowable charging temperature range.

29