3.Press [p] (PLAY) to turn on the camera.
This will cause an image to appear on the TV screen, without anything appearing on the camera’s monitor screen.
•Pressing [ON/OFF] (Power) or [r] (REC) will not turn on the camera while the AV cable is connected.
•You also can change the aspect ratio of the screen and the video output system (page 162).
4.Now you can display images and play back movies as you normally do.
IMPORTANT!
•Before connecting to a TV to display images, be sure to configure the camera’s
[r] (REC) and [p] (PLAY) buttons for “Power On” or “Power On/Off” (page 161).
•Audio is initially output by the camera at maximum volume. When you first start displaying images, set the TV volume control at a relatively low level and then adjust it as required.
NOTE
•Audio is stereo.
•Some TVs may not be able to output images and/or audio correctly.
•All icons and indicators that appear on the monitor screen also appear on the TV screen. You can use [8] (DISP) to change the display contents.
•Normally connecting the camera to a TV during recording will cause the camera’s monitor screen to go blank and display the image picked up by the camera on the TV screen. If you are using Wide Shot (page 69), the image will be shown on the monitor screen but not the TV screen. Image recording can be performed in either case.
110 | Viewing Snapshots and Movies |
|