NOTE

Spending a long time using movie recording will cause the camera to become slightly warm to the touch. This is normal and does not indicate malfunction.

The camera also records audio. Note the following points when shooting a movie.

Take care that the microphone is not blocked by your fingers, etc.

Good recording results are not possible when the camera is

 

too far away from what you are trying to record.

Microphone

 

– Operating camera buttons while shooting can cause button

 

 

 

noise to be picked up in the audio.

 

Shooting a very bright subject can cause a vertical band or a pink cast on the

 

monitor screen image. This does not indicate malfunction.

 

When using the camera’s built-in memory or certain types of memory cards, it can

 

take too much time to record data, which can result in breaks in the image and/or

 

audio. This condition is indicated by » and Y flashing on the monitor screen. To

 

avoid loss of movie frames, use of a memory card with a maximum transfer speed

 

of at least 10MB per second is recommended (page 125).

 

Only digital zoom can be used for zooming during movie recording. Since optical

zoom is not possible while recording a movie, zoom as required before pressing [0] (Movie) to start recording.

• The effects of camera movement in an image become more pronounced when you shoot close up or with a large zoom factor. Because of this, use of a tripod is recommended under these conditions.

• Focus is fixed while movie recording is in progress.

Shooting a Snapshot while Shooting a Movie

1.While a movie is being recorded, press the shutter button. Movie recording continues after the snapshot is recorded.

NOTE

• You can use [2] ( ) while shooting a movie to change the flash mode setting.

Movie recording is interrupted for a few seconds at the point where a snapshot is recorded.

Shooting a snapshot during movie recording is not possible when shooting with any of the following.

Some BEST SHOT scenes

easy Mode

49Recording Movie Images and Audio