Specifying the Fraction Display Format

To specify this fraction

display format:

Perform this key operation:

Mixed1Nc1(ab/c)

Improper1Nc2(d/c)

Specifying the Statistical Display Format

Use the following procedure to turn display of the frequency (FREQ) column of the STAT Mode STAT editor screen on or off.

To specify this:

Perform this key operation:

Show FREQ Column 1Nc3(STAT)1(ON)

Hide FREQ Column 1Nc3(STAT)2(OFF)

Specifying the Decimal Point Display Format

To specify this decimal

point display format:

Perform this key operation:

Dot (.)1Nc4(Disp)1(Dot)

Comma (,)1Nc4(Disp)2(Comma)

•The setting you configure here is applied for calculation results only. The decimal point for input values is always a dot (.).

k Initializing the Calculation Mode and OtherSettings

Performing the following procedure initializes the calculation mode and other setup settings as shown below.

19(CLR)1(Setup)=(Yes)

This setting:

Is initialized to this:

Calculation Mode

COMP

Input/Output Format

MthIO

Angle Unit

Deg

Display Digits

Norm1

Fraction Display Format

d/c

Statistical Display

OFF

Decimal Point

Dot

•To cancel initialization without doing anything, press A(Cancel) instead of =.

E-9