6-5-14 Tests

The following shows the meaning of each item in the case of list data specification.

Data..............................

data type

μ1 .................................

sample mean value test conditions (“G μ2” specifies two-tail

 

test, “< μ2” specifies one-tail test where sample 1 is smaller

 

than sample 2, “> μ2” specifies one-tail test where sample 1

 

is greater than sample 2.)

List(1) ...........................

list whose contents you want to use as data of sample 1

 

(List 1 to 26)

List(2) ...........................

list whose contents you want to use as data of sample 2

 

(List 1 to 26)

Freq(1)..........................

frequency of sample 1 (1 or List 1 to 26)

Freq(2)..........................

frequency of sample 2 (1 or List 1 to 26)

Pooled ..........................

pooling On (in effect) or Off (not in effect)

Save Res......................

list for storage of calculation results (None or List 1 to 26)

Execute ........................

executes a calculation or draws a graph

The following shows the meaning of parameter data specification items that are different from list data specification.

x¯ 1 .................................

mean of sample 1

 

x1σn-1 ............................

standard deviation (x1σn-1

> 0) of sample 1

n1 .................................

size (positive integer) of sample 1

x¯ 2 .................................

mean of sample 2

 

x2σn-1 ............................

standard deviation (x2σn-1

> 0) of sample 2

n2 .................................

size (positive integer) of sample 2

After setting all the parameters, use c to move the highlighting to “Execute” and then press one of the function keys shown below to perform the calculation or draw the graph.

• 1(CALC) ... Performs the calculation.

• 6(DRAW) ... Draws the graph.

20070201