Unpack your heater and remove the two feet assemblies from the package. Refer to
Fig. 1 below:
1. Make sure the heater is unplugged and in
the ”OFF” position.
2. TURN THE HEATER UPSIDE DOWN.
3. Make sure the tall part of the foot is set
towards the front part of the heater
according to the direction shown.
4. Insert the tabs on top of each foot into the
holes at the bottom of the cabinet and slide
forward. ENSURE THAT EACH FOOT IS
SECURED FIRMLY IN PLACE.
5. Turn the heater upright.
Your heater is now ready for use.
CAUTION: Risk of fire – Do not
operate heater without feet attached. Operate heater in
upright position only (feet on bottom, controls on top). Any other position could create a
hazardous situation.
IMPORTANT This heater is for use on 120V volts. The cord has a plug as shown at A
in the following
Figure. An adapter as shown at C is available for connecting three-blade grounding-
type
plugs to two-slot receptacles. The green grounding lug
extending from the adapter must
be connected to a permanent ground such as a properly grounded outlet box. The
adapter should not be used if a three-slot grounded receptacle is available.
Fig. 1
-
Upside down view
tabs
(C)
(D)
Adapte
r
Metal Screw
Cover Of
Grounded outlet
Box
Grounding
Means
Grounding
Pin
(A) (B)
•
Place the heater on a firm level surface free from obstructions, and at least 3
ft. away from any wall and any other objects such as furniture, curtains, plants
or combustible material.
• With the Power and Setting Control “A” in the ”OFF”
position, plug the heater
into a grounded 120V outlet.
• Turn the heater ”ON” by turning the Power and Setting Control “A”
clockwise
to your desired power setting (LOW or HIGH). The Power Indicator Light “C”
will illuminate.
• Turn the Thermostat Control “B” to your desired setting from “MIN” to
“MAX”.
Setting for Optimum Comfort: When the room reaches a comfortable temperature,
slowly turn the Thermostat Control “B” counter-clockwise until the heater turns off.
This is the point at which the thermos
tat setting equals the room temperature. At this
setting, the thermostat will automatically turn the heater on and off to maintain this
selected temperature.
CAUTION: This heater includes a Thermal Cut-Off Overheat Protection System that
shuts the unit off if it overheats due to abnormal conditions. If this occurs, the
Overheat
Safety Light “D” will turn on. Turn the heater ”OFF”
, unplug it, and inspect and remove
any objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it ba
ck
in, and resume normal operation.
Feet
Carry Handle
(behind unit)
B
A
C
D
Control Panel Functions
Power and Setting Control Power Indicator Light
Thermostat Control Overheat Safety Light
A
B
C
D