
To initialize the Label Printer
1. | Turn power off. |
|
2. | While holding down the PRINT and ESC keys, | INT? |
| press ON to turn power on. | |
3. | the ON key only. | |
Keeping PRINT and ESC held down, release |
|
•This prompt confirms whether or not you want to initialize the Label Printer.
4.Press SET to initialize the Label Printer or ESC to abort the reset operation.
• The following table shows the initial settings.
Item | Reset |
Display | Cleared |
Memory | Cleared |
EFFECT | CANCEL |
NO | |
MIRROR | OFF |
DENSITY | 3 |
WIDTH | OFF |
Troubleshooting
Problem | Possible Cause | Action | |
|
|
| |
ERR! message | • Attempt to input two ¥ | • Use only one ¥mark. | |
on the display. | marks within the same | Only two lines of text can | |
* This message | text. | be input, so text can | |
| contain only one ¥mark. | ||
appears on the |
| ||
• Attempt to input ¥ mark | • Do not use ¥ marks. | ||
screen for about | |||
one second. | while 6mm is specified as | 6mm tape can have only | |
the tape width. | one line of text, so text | ||
| |||
|
| cannot contain any ¥ | |
|
| marks. | |
| • Label text containing a ¥ | • Delete the ¥ mark to | |
| mark was input and then | print on 6mm tape or | |
| tape width specification | switch back to a wider | |
| was changed to 6mm. | tape. | |
| (ERR! message appears |
| |
| when you try to perform a |
| |
| print operation.) |
| |
| • Text that is longer than | • Shorten the text to be | |
| 5.5cm when stamp | printed and try again. | |
| printing is selected. |
| |
| • Attempt to print a stamp | • Change the tape width | |
| while 6mm is specified for | setting to OFF and try | |
| the tape width. | printing the stamp again. | |
|
|
| |
FUL! message on | • Both text memory areas | • Delete text from one of | |
the display. | (AREA 1 and AREA 2) | the text memory areas | |
* This message | already contain text. | and then store the new | |
| text. | ||
appears on the |
| ||
|
| ||
screen for about |
|
| |
one second. |
|
| |
|
|
| |
BATT message | • Battery power is too low. | • Replace batteries. | |
on the display. |
|
| |
|
|
| |
ERR! message | • Memory data has become | • Initialize the Label | |
on the display. | corrupted for some reason. | Printer. | |
|
|
|