
1. While the input screen is on the display, press | STR? |
FUNCTION and then 1 (MEMO). | |
• Note that text recalled from memory will replace | |
any text currently on the display. |
2. Press L to change to the text recall prompt.
CAL?
2.Press L twice to change to the text delete prompt.
3.Press SET.
•If all of the text does not fit on the display, you can use Hand J to scroll it to the left and right.
DEL?
ABCD
3. Press SET.
•If all of the text does not fit on the display, you can use H and J to scroll it to the left and right.
ABCD
Area 1 text
4.Use K and L to select Area 1 or Area 2 then press SET.
Area 1 text
OK?
4. Press L to change to Area 2.
•Use K and L to switch between Area 1 and Area 2.
5.Press SET to recall the text from the area that is currently on the display.
•Note that recalling data from memory replaces anything that is currently on the input display. Memory text cannot be appended.
To delete text from memory
1.While the input screen is on the display, press FUNCTION and then 1 (MEMO).
CASI
Area 2 text
CASI
STR?
5. Press SET to delete the text from the area that is currently on the display.
Part 8 Reference
This section contains information about the Label Printer that you can use as reference when you need it.
Replacing the Tape Cutter Blade
The tape cutter blade is designed to provide approximately 3,000 cuts. Use the following procedure to replace the blade whenever it starts to cut poorly.
To replace the tape cutter blade
1.Make sure that the Label Printer is switched off.
2.Open the tape cartridge compartment cover.