Casio LK230ES1A Number, Selected Tone, ■ Short Sampling, Controlling the Keyboard Sounds, where you want to store the sound, 5. Output the sound from the microphone

Controlling the Keyboard Sounds

5. Output the sound from the microphone.

2. While holding down 5, press the voice pad (bs,

The Digital Keyboard will start sampling automatically,

bt, or ck) that corresponds to the tone number

and stop after one second.

where you want to store the sound.

What you sample is stored as tone number 401.

• The relationship between tone numbers and voice pads

Flashes

is shown below.

Selected Tone

402

403

404

Number

S a m p l i n g

Pressed Voice Pad

Pad 1 (bs)

Pad 2 (bt)

Pad 3 (ck)

Example: When voice pad 3 (Tone Number 404) is

Lights

selected

Flashes

V o i . P a d 3

O r i g i n a l

6. Try playing something on the keyboard.

Record standby is entered when you release 5.

• You can press pad 4 or 5 (cl or cm) to sound the

Flashes

sampled sound (page E-9).

• Sampling will not start if the volume of the sound picked up

W a

i

t i

n

g

by the microphone is too low.

• A new sample replaces sample data currently assigned to

tone number 401. All of the old data (including short

sampled sounds) is deleted.

3. Output the sound from the microphone.

■ Short Sampling

Sampling starts automatically and stops after about 0.3

With short sampling, you can sample up to three sounds,

seconds.

each one with a duration of approximately 0.3 seconds. You

Lights

can sound the short sampled sounds using voice pads

1 through 3.

1. Connect a microphone to the keyboard.

V o

i

. P a d 3

Refer to steps 1 through 3 under “Full Sampling” (page

E-13).

4. Try playing something on the keyboard.

You also can sound the sampled sound by pressing the

voice pad you pressed in step 2.

• Sampling will not start if the volume of the sound picked up

by the microphone is too low.

• Sampling a new sound deletes the sound assigned to the

same tone number and the full sampling sound (page

E-13).

E-14