Quick Start Guide
Cisco Small Business Model SD208P
8-Port 10/100 Unmanaged Switch with PoE
Package Contents
•SD208P Switch
•Power Adapter
•Quick Start Guide
1 Product Overview
Thank you for choosing the SD208P
The SD208P supports IEEE 802.3af Power over Ethernet on ports 1 through 4 with a total power budget of 32 Watts. This provides power over
The SD208P has a built in feature to aid network performance at times of excessive load called Port Priority. This feature integrates Port Based QoS on all 8 ports to meet different service requirements on voice, video and data transformation. This feature can be useful during excessive loads, for example, when one type of traffic may require priority over another.
Front Panel
The LEDs are located on the front panel of the Switch.
Link/ACT
PoE Status
PoE Max (Yellow) This LED lights up and remains lit when the switch is providing more than 80% maximum PoE power (when the total power supplied reaches the 25.6 W level across ports
Back Panel
The Ethernet network ports are located on the back panel of the Switch. All ports are
Ethernet
Side Panels
There is a physical security slot located on the side of the Switch. The security slot is where you can attach a lock to protect the Switch from theft.
Placement Options
Set the Switch on its four rubber feet, or mount the Switch on a wall.
Before mounting the switch onto a wall, it is important to consider the following:
•Ensure the wall is strong enough to support the switch, a minimum of 1/2” of sheet rock is recommended.
•Do not operate the switch in an area that has reduced air flow, or exceeds an ambient temperature of 104 degrees (40 C).
•The switch can be mounted either horizontal or vertical.
•Mounting screws should have a head 5.5mm wide, 2mm deep, and the shaft of the screw should be at least 13mm long and 2.9mm wide.
To use the
STEP 1 The
STEP 2 Maneuver the Switch to insert the screws into the two slots, then slide the switch downward onto the screws.