Setting Name | Description |
Subnet Mask | Configuration of this setting is required when “Off” is selected for “DHCP”. |
| Enter a subnet mask value, which specifies the range of the IP address of |
| the subnet to which the Data Projector/computer belongs. The subnet mask |
| consists of four values in the range of 0 to 255, separated by periods (such |
| as 255.255.255.0). |
|
|
Default | Configuration of this setting is required when “Off” is selected for “DHCP”. |
Gateway | When “Access Point” is selected for “Access Mode”, specify the same value |
| as the wireless LAN access point. |
|
|
Channel | Configuration of this setting is required when “Ad Hoc” is selected for |
| “Access Mode”. When there is a large number of devices performing wireless |
| LAN communication using frequencies in the same frequency band (2.4 GHz) |
| used by the Data Projector, you can improve communication performance by |
| assigning different channels to each wireless LAN network. Normally you |
| should leave this item set to “Auto” (initial default setting). |
| Auto*: |
| Automatically assigns a communication channel for wireless LAN |
| communication. If “Auto” is selected on the Data Projector, also select |
| “Auto” for the computer as well. |
| 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11: |
| Specify a channel that should be used for wireless LAN communication. |
| The same channel must be set on the Data Projector and the computer |
| that will be communicating with each other over the wireless LAN |
| connection. |
|
|
43