Connecting to the Mains Water Supply
The water supply hose is located inside the drum.
sConnect the bent end of the hose to the threaded inlet of the electrovalve located at the rear of the washing machine.
sConnect the other end of the hose to the water inlet. Then securely tighten the connecting nut.
The drain hose must be securely fastened to the outlet to prevent any risk of the drain hose becoming detached and causing flooding.
The washing machine must be connected to the mains water supply, using the new supply hoses supplied with the appliance. Do not use water supply hoses that have been used previously.
For your washing machine to work properly, the mains water pressure must be between 0.05 and 1MPa (0.1 - 10 bar).
Drainage Connection
sIt is recommended that you have a fixed drainage outlet 50 to 70 cm from the floor.
sAvoid the drain hose being too tight, kinked or restricted.
sThe water outlet can either be connection to a water drain or to a sink outlet spigot. This connection should be a minimum of 50cm and a maximum of 110cm from the floor. The drain hose should be no longer than 4m in length to ensure good performance from the dishwasher.
sAfter connecting the water supply, check to ensure there are no leaks.
fig. 4
fig. 5 |
fig. 6 |
4
