Installation
To fix your extractor to the ceiling, proceed as follows
1.Mark the fixing positions of the wall plugs that will be used to secure your extractor to the ceiling, as shown in fig. 4
2.Drill 4 holes and insert the wallplugs, ensuring that they are suitable for use with your ceiling. If the extractor is to be fixed directly to ceiling joists then wall plugs may not be required.
3.Fit the vent adaptor (G) to the body of the extractor, using the 2
4.Calculate the height of the chimney section as follows
Length of support section = Ceiling height – (285 + H + Hob height above floor)
H= 600 min for electric hobs (650mm recommended) H=700mm minimum for gas hobs (750mm recommended)
5.Fix the 2 support sections(A) at the required length using 4
6.Fix the support sections to the main motor body using 4 machine screws.
7.Slide the two decorative sections over the frame sections.
8.If your extractor is to be used as a recirculation device, fit the deflector panel (I) onto the top of the frame section, as shown.
9.With assistance, mount the entire assembly to the ceiling using appropriate fixing screws. Once this operation has been completed, the extractor is fully supported by the ceiling fixings.
10.Mount the top chimney section (D) to the top of the frame section using 2 screws (E)
11.If using the extractor to extract air outside, connect the duct pipe to the vent adaptor (G), ensuring a good seal to prevent air escaping. (The lower decorative section
(B) can be raised and tape to allow access to the outlet adapter (G))
| 191 |
Fig.4 | 203 |
| |
| E |
| D |
| B |
| I |
| A |
| G |
Fig.5 |
|
7
