CDA FW380 Know Your Appliance, DESCRIPTION OF THE APPLIANCE Fig, Installation, AControl panel

Models: FW380

1 30
Download 30 pages 33.99 Kb
Page 5
Image 5
KNOW YOUR APPLIANCE

KNOW YOUR APPLIANCE

The appliance you have just bought, marked by the DESCRIPTION OF THE APPLIANCE (Fig. 1) symbol, allows the freezing - in of fresh and cooked food, the production of ice cubes and the storage of frozen food. Please read these instructions carefully, as they include a description of your appliance and the useful hints to enable you to achieve the best performances required to freeze fresh food and to store already frozen food.

DESCRIPTION OF THE APPLIANCE (Fig. 1)

A)Control panel

1.Operation control lamp (green light)

2.Temperature control lamp (red alarm light) with acoustic signal - if present

3.Fast freeze control lamp (yellow light)

4.Fast freeze switch

5.Temperature control knob (thermostat)

6.Open door alarm switch - if present

B)Baskets (freezing - in and storage baskets)

C)Storage basket only.

Some models are supplied with containers filled with cooling liquid(eutectics): remove them from the back of the basket (C) and position them next to each other inside the basket.

INSTALLATION

Ensure that the appliance is not damaged. Transit damages must be reported to your dealer within 24 hours of receipt of the appliance. The appliance should not be installed close to heat sources such as cookers, central heating, boilers, sunlight, etc. It must however be located in a well ventilated dry space. If the following type of installation cannot be avoided, respect these side distances:

a)between appliance and oil or coal stoves: 30 cm minimum.

b)between appliance and gas or electric cooker: 3 cm minimum.

The appliance must stand on a stable and level surface: install it following the instructions given on the rear of the template, delivered with the appliance. Leave the appliance to stand for two hours before connecting it to the electricity supply. We suggest that during this time the interior is cleaned with a sponge dampened in a solution of water and vinegar, after which the baskets can be fitted into the appliance.

Attention: Accessibility to the plug has to be guaranteed even after installation of the appliance to disconnect it, if required. Alternatively, connect the appliance to the mains by means of a two-pole switching device with contact separation of 3 mm situated in an accessible position.

14

Page 5
Image 5
CDA FW380 manual Know Your Appliance, DESCRIPTION OF THE APPLIANCE Fig, Installation, AControl panel