CDA HCC570 manual How to Install the Hob, How to install the hob, 3 cm

How to Install the Hob

How to install the hob:

Overall dimensions of the hob:	Width: 580mm	Depth: 510mm
Worktop cut-out dimensions:	Width: 560mm	Depth: 490mm

1.Make the required hole in the worktop. Note that before doing this, check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig 4) shows a 61.5mm gap from the wall to the cut-out edge. The distance for the hob, when fitted, to the back wall is 50mm.

2.Position the hob seal, as shown in the diagram below (Fig 6), ensuring that the ends meet without overlapping. Do not use silicone type sealant.

3.Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in the following diagram (Fig 7). Remove any excess sealant after tightening the brackets.

	>60mm
	490mm	650mm
	400mm
	560mm
190mm	190mm
Fig.4	Fig.5
	3cm	4cm
Fig.6	Fig.7

8