CDA RC 9021 manual Electronic Clock fig, Normal Cooking without the Use of the Programmer

6

Electronic Clock (fig. 4)

The programmer is equipped with an electronic clock with illuminated numbers which indicates hours and minutes. Upon immediate connection of the oven or after a power cut, three zeros will flash on the programmer display.

To set the correct time of day it is necessary to push the button and then the or button until

you have set the correct time. In another way push simul­taneously­ the two buttons and at the same time push the or button.

Note: If the clock is reset it deletes any previously set programs.

Normal Cooking without the Use of the Programmer

To manually use the oven, that is, without the aid of the programmer, it is necessary to cancel the flashing AUTO by pushing the button (AUTO will be switched off and the symbol will go on - Fig. 5). Attention: If the AUTO is steadily lit (which means a cooking program has already been set), the program can be cancelled and switched to manual by pushing the button .

If the oven is switched on, you must switch off manually.

Electronic Timer

The timer program consists only of a buzzer which may be set for a maximum period of 23 hours and 59 minutes. If the AUTO is flashing push the button.

To set the time, push the button and the or until you obtain the desired time in the panel (fig. 6). Having finished the setting, the clock hour will appear on the panel and the symbol will be illuminated.

The countdown will start immediately and may be seen at any moment on the panel by simply pressing the button .

At the end of the time, the symbol will disappear and the buzzer will sound and continue for approximately 7 minutes or until a button is pressed (not the / buttons).

After a short time the display will revert back to the time of day.

Setting the Frequency of the Audible Signal

The buzzer has 3 different tones and can be changed by pressing the button, but only when the time of day is displayed.

Fig. 5

Fig. 6