Celestron 60EQ manual Attaching the Accessories, Attaching the Finderscope

2.Locate the declination slow motion control (9) and attach to the mount by tightening the set screw on the control cable. See Figure 1-3. The set screw should be tightened down hard on the flat surface of the cable holder after backing off the cable about 1/4" from being fully engaged. This method helps ensure there is no slippage when using the cable.

3.Locate the right ascension slow motion control (19) and attach it the same way as the declination cable was attached.

Attaching the Optical Tube

You are now ready to put the telescope optical tube (2) onto the equatorial mount (20).

1.Remove the two locking wing nuts from the telescope optical tube (2).

2.Place the telescope tube on the mount so that the treaded post at the bottom of the tube's mounting platform (21) go through the holes on the top of the mount.

3.Thread a wing nut onto the end of the threaded posts and tighten to secure the tube to the mount.

Attaching the Accessories

Your telescope comes with the following optical accessories:

•20mm eyepiece 1¼"

•4mm eyepiece 1¼ "

•3x Barlow Lens 1¼"

•1.5x Erect Image Eyepiece 1¼"

1.Remove the caps from the focuser (5).

2.Place the chrome barrel end of the eyepiece into the star diagonal (see Figure 1- 4). Lock it into place with the thumb screw on the side of the star diagonal.

3.The PowerSeeker comes with a 1.5x erecting eyepiece, primarily for daytime terrestrial viewing. This eyepiece corrects the image you see in your telescope, so that it’s both right side up and corrected from left to right. Without this eyepiece, the image you see is reversed from left to right, when using the standard diagonal. To use the erecting eyepiece, remove the diagonal and insert the erecting eyepiece directly into the focuser. Then use a low power eyepiece such as the 20mm, inserting it directly into the erecting eyepiece. See Figure 1-5.

4.Your telescope also comes with a 3x Barlow lens which triples the magnifying power of each eyepiece (see Magnification section of the manual). To use the barlow lens, remove the diagonal and insert the barlow lens directly into the focuser. Then start by using the low power eyepiece such as the 20mm, and insert it either directly into the barlow lens or into the diagonal. See Figure 1-5.

Attaching the Finderscope

Figure 1-3

Figure 1-4

Figure 1-5

1.Remove the two small, silver thumbscrews located on top of the telescope tube. See Figure 1-6.

2.Place the finderscope bracket (4) over the two holes in the telescope tube, lining up the holes on the finderscope bracket with those in the telescope tube.

3.Insert the thumbscrews through the finderscope bracket and thread them into the telescope tube.

5