Century HES60 Service Instructions, Maintenance of Motors, Replacing Light Bulbs, 10006943

Service Instructions

WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury.

Maintenance of Motors

The motors used on the fan and the flame generator assembly are prelubricated for extended bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater unit is recom- mended.

WARNING: Make sure the power is turned off before proceeding.

Replacing Light Bulbs

This stove uses two clear 120 Volt, 40 Watt, E-12 socket base light bulbs (small base, chandelier candle type). The 40 Watt bulbs are located under the log set/ember bed. For convenience, if one of the bulbs burns out, it may be a good idea to replace both of the light bulbs.

1.Turn off power to the unit by unplugging the power cord.

2.Let stove cool if it has been operating.

3.Remove the access plate on the back of the stove by removing the screws. You should have a clear view of the light bulbs. Put your hand over the silver flame generator to remove or replace the light bulb(s).

CAUTION: Be careful not to touch or bend the flame generator.

4.Examine the bulbs to determine which bulb needs to be replaced.

5.Unscrew defective bulb(s).

6.Install new 40 Watt light bulb(s).

7.Replace access plate. Plug power cord into wall outlet.

WARNING: Do not exceed 40 watts per bulb. Use of higher rated bulbs may result in a fire, causing property damage or per- sonal injury.

6 10006943