INSTALLATION PROCEDURE
MODELS SEF-10 THROUGH SEF-30
When shutter is mounted to fan assembly:
1.Cut square wall opening size ½” larger than fan blade diameter.
2.From inside of building / room, center fan assembly over wall opening. Fan must be positioned so that junction box is located at bottom and shutter is level and square, with shutter blades opening upwards.
3.Lag fan to wall through mounting holes in shutter gusset, using appropriate fasteners (by others).
4.Rotate fan impeller by hand, ensuring that it is unobstructed and rotates freely.
5.Make electrical connections to fan junction box.
When shutter and fan assembly are mounted separately:
1.Cut wall opening size ½” larger than fan blade diameter.
2.From inside of building / room, center fan assembly over wall opening. Fan must be positioned so that junction box is located at bottom.
3.Lag fan to wall through wire hooks on guard, using the appropriate fasteners (by others).
4.Apply caulking compound (by others) to rear of shutter gusset.
5.From outside of building / room, center shutter over wall opening, ensuring that shutter is level and square, with shutter blades opening upwards.
6.Lag shutter to wall through mounting holes in shutter gusset, using appropriate fasteners (by others).
7.Rotate fan impeller by hand, ensuring that it is unobstructed and rotates freely.
8.Make electrical connections to fan junction box.
MODEL PEF-10 THROUGH PEF-30
1.Cut wall opening size ½” larger than fan venturi opening.
2.From inside of building / room, center fan panel assembly over wall opening. Fan must be positioned so that junction box is located at bottom.
3.Lag fan to wall through mounting holes in panel, using appropriate fasteners (by others).
4.Rotate fan impeller by hand, ensuring that it is unobstructed and rotates freely.
5.Make electrical connections to fan junction box.
MODELS
1.Cut wall opening size ½” larger than fan blade diameter.
2.From inside of building / room, center fan assembly over wall opening. Fan must be positioned so that junction box is located at bottom.
3.Lag fan to wall through wire hooks on fan guard, using the appropriate fasteners (by others).
4.Rotate fan impeller by hand, ensuring that it is unobstructed and rotates freely.
5.Make electrical connections to fan junction box.
RECOMMENDED MAINTENANCE
1.When undertaking maintenance or service work, ensure that electrical service to fan is locked in the “OFF” position to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device such as a tag to service panel.
2.Do not
3.Maintenance or service work must be performed by a qual- ified person in accordance with all applicable codes and standards, including local fire codes.
4.Motor bearings are factory lubricated and do not require additional lubrication.
5.Remove airborne contaminants that have settled on motor using an air hose or vacuum.
6.Clean fan blades, guard or shutter using a mild detergent. Do not allow cleanser to come in contact with fan motor or electrical parts.
LIMITED WARRANTY
This equipment is warranted to be free from defects in material and workmanship for a period of one (1) year from date of purchase. Any units or parts which prove to be defective during warranty period will be repaired or replaced at Vendor’s option. Vendor is not responsible for any removal, installation or transportation costs.
Motors are warranted separately by motor manufacturer for a period of one (1) year, and should be returned to nearest authorized motor service center for repair.
All warranty claims must be processed through point of purchase.
WIRING PROCEDURE
USA | www.continentalfan.com |
Continental Fan Manufacturing Inc. | |
203 Eggert Rd. |
|
Buffalo, NY 14215 |
|
Tel: | Toll: |
Canadawww.aeroflo.com
Aeroflo Inc.
Mississauga, ON L4Z 3E3
Tel:
