CFM Corporation HEF22 installation instructions Replacing the Light Bulbs, 10008388

Replacing the Light Bulbs

Depending on your model, the fireplace uses two (2) or three (3) clear 120 Volt, 60 Watt, E-12 socket base light bulbs (small base, chandelier candle type) located under the ember bed. Units with overhead lights (Fig.

9)use two (2) clear 120 Volt, 5 Watt, E-12 socket base light bulbs (small base, chandelier candle type) located above the logs. For convenience, if one of the light bulbs burns out, it may be easier to replace all of the light bulbs at the same time.

Do not exceed 60 Watts per bulb for the ember bed bulbs and 5 Watts per bulb for the overhead lights. Use of higher rated bulbs may result in a fire, causing proper- ty damage, personal injury or loss of life.

1.Turn off power to the unit.

2.Let fireplace cool if it has been operating.

3.Remove fixed front panel, or open doors (depend- ing on model).

4.Locate two (2) screws that hold the refractory (brick patterned) bracket together with the ember bed. (Fig. 6) (Not applicable to HEF22)

Remove Screws

Fig. 6 Remove screws that hold refractory bracket with ember bed.

5.Remove those two (2) screws using an appropriate screwdriver. One screw is located on either side of the unit.

Pull Here (both sides)

Fig. 7 Pull ember bed out of unit.

6.Pull the ember bed out of the unit, by gently pulling towards you and only slightly upwards. Depending on the model, you can remove the refractory prior to removing the ember bed.

7.Looking into the opening of the unit under the ember bed, visually locate the light bulbs.

8.Remove the light bulbs by unscrewing them out of the bases, turning them counterclockwise. You can use one hand to hold the light socket in place, if required.

60 W Light Bulbs

Fig. 8 Remove and replace light 60 W bulb(s).

5 W Light Bulb

Fig. 9 Remove and replace 5 W bulb(s).

9.Install the new light bulb(s) by turning the light bulb into the base clockwise. You can use one hand to hold the light socket in place, if required.

10.Reposition the ember bed. If required, gently raise the refractory panels, one at a time, to tuck the ember bed edge underneath them.

11.Reposition the refractory bracket, aligning the refractory in place as required.

12.Reinstall the two (2) screws removed in Step 5.

9

10008388