push button is
Radio Controls

F.C.C. rules prohibit adjustments to or modification of receiver and/or remote control transmitter circuitry except for changing the code setting and replacing the remote control transmitter battery. THERE ARE NO USER SERVICEABLE PARTS.

Manufactured under 1 or more of the following U.S. patents: RE29,525: 4,037,201;

4.750.118: 4.806.930

Other Patents Pending

 

 

ACTIVATE THE OPENER ONLY WHEN DOOR IS IN FULL VIEW, FREE OF OBSTRUCTION AND PROPERLY ADJUSTED . NO ONE

SHOULD ENTER OR LEAVE GARAGE WHILE DOOR IS IN MOTION. DO NOT ALLOW CHILDREN TO OPERATE REMOTES OR DOOR CONTROL BUTTONS. DO NOT ALLOW CHILDREN TO PLAY NEAR THE DOOR.

Your garage door opener receiver and remote control transmitter have been set at the factory to a matching code. If you want to CHANGE your code or purchase additional remotes, follow the Instructions below. The code in any NEW remote control must be set to match the code in the original remote control.

MATCH/CHANGE THE CODE IN REMOTE CONTROL(S)

SET CODE SWITCHES IN ALL REMOTES TO MATCHING POSITIONS

PROCEDURE: Slide battery compartment cover back to access the code switches in your single function remote control and any new remote control

Place remote controls side by side as shown and set code switches in ALL remotes to matching positions (+, -, 0). Use a pen or screwdriver to slide the switches.

NOTE: Instructions for matching the code switches in two-channel and multi-function remote control transmitters are included with those accessories.

MATCH/CHANGE THE CODE IN THE RECEIVER

GARAGE DOOR OPENERS

WITH RECEIVER SMART CODE BUTTON

1.Press the RECEIVER Smart Button on the back panel of the opener as shown The adjacent indicator light will turn ON.

CAUTION: Door will begin to move immediately if any transmitter has been activated.

If this occurs, wait until the door has completed its UP or DOWN cycle. Then begin again at Step 3.

2.STAND AWAY FROM THE DOOR and press the remote control transmitter push button The indicator light will turn OFF and the door will move. Receiver and remote control(s) codes now match. The opener will operate when either the door

control button or the remote control transmitter

pressed

NOTE: If the remote control transmitter push button is not pressed within 30 seconds, the indicator light will turn OFF. In that case, begin again at Step 1.

REMOTE CONTROL

Push

TRANSMITTER

Button

 

23