INSTALLATION STEP 7
Install the Light
ïPress the release tabs on both sides of lens. Gently rotate lens back and downward until the lens hinge is in the fully open position. Do not remove the lens.
ïInstall up to a 100 watt maximum light bulb in each socket. The light will turn ON and remain lit for approximately
ïReverse the procedure to close the lens.
ïIf the bulbs burn out prematurely due to vibration, replace with a Garage Door Opener bulb.
NOTE: Use only standard light bulbs. The use of short neck or speciality light bulbs may overheat the endpanel or light socket.
CAUTION
To prevent possible OVERHEATING of the endpanel or light socket,
•DO NOT use short neck or specialty light bulbs.
•DO NOT use halogen bulbs. Use ONLY incandescent.
100 Watt (Max)
Standard Light Bulb
Release Tab
Lens Hinge
INSTALLATION STEP 8
Attach the Emergency Release Rope and Handle
ïThread one end of the rope through the hole in the top of the red handle so ìNOTICEî reads right side up as shown. Secure with an overhand knot at least 1" (2.5 cm) from the end of the rope to prevent slipping.
ïThread the other end of the rope through the hole in the release arm of the outer trolley.
ïAdjust rope length so the handle is 6 feet (1.83 m) above the floor. Ensure that the rope and handle clear the tops of all vehicles to avoid entanglement. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.
WARNING
To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
•If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
•NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
Overhand
Knot
Trolley |
| Trolley |
| Rope | Release Arm |
|
|
Emergency
Release Handle
14