Planning
Identify the type and height of your garage door. Survey your garage area to see if any of the conditions below apply to your installation. Additional materials may be required. You may find it helpful to refer back to this page and the accompanying illustrations as you proceed with the installation of your opener.
SECTIONAL DOOR INSTALLATION
Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, steel, aluminum,
door with glass panels, etc.). See page 20 for details.
Header Wall
— — | Door | |
— | ||
Center | ||
| ||
— — — |
| |
— — |
|
FINISHED CEILING
Support bracket & fastening hardware is required.
See page 13.
Motor Unit
Extension Spring |
|
OR | Wall- |
mounted | |
Torsion Spring | Door |
Control | |
Access Door |
|
Safety |
|
Reversing |
|
Sensor |
|
Gap between floor and bottom of door must not exceed 1/4"
Safety Reversing Sensor
FINISHED CEILING
ONE-PIECE DOOR WITHOUT TRACK Support bracket
& fastening hardware is required. See page 13.
Motor Unit
Header
Wall
Wall- mounted Door Control
Access
Door
Safety
Reversing Sensor
Gap between floor and bottom of door must not exceed 1/4"
Safety
Reversing Sensor
ONE-PIECE DOOR WITH TRACK
Access
Door
Safety Reversing Sensor
Gap between floor and bottom of door
must not exceed 1/4"
Safety Reversing Sensor
4