35
1. Press and release the “learn”
button on the motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote* that you wish to operate
your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The
door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚® 315 MHz remote controls.
NOTICE: If this Security✚® garage door opener is operated with a non-rolling code transmitter, the technical measure
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.

To Add or Reprogram a Hand-held Remote Control

USING THE “LEARN” BUTTON USING THE DOOR CONTROL

1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button,
press and hold the LIGHT button on
the door control.
3. Continue holding both buttons while
you press the push bar on the door
control (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code.
If light bulbs are not installed, two
clicks will be heard.

*3-Button Remotes 315 MHz

If provided with your garage door opener, the
large button is factory programmed to operate it.
Additional buttons on any Security✚® 3-Button
remote or compact
remote can be
programmed to
operate other
Security✚® garage
door openers.

To Erase All Codes From

Motor Unit Memory

To deactivate any unwanted remote,
fi rst erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator
light goes out (approximately 6
seconds). All previous codes are now
erased. Reprogram each remote or keyless entry you
wish to use.