INSTALLATION STEP 12
Connect Door Arm to Trolley
Inner Trolley
SECTIONAL DOORS ONLY
•Make sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the door) about 2" as shown in Figures 1, 2 and 3.
•Figure 1:
–Fasten straight door arm section to outer trolley with the 5/16"x1" clevis pin. Secure the connection with a ring fastener.
–Fasten curved section to the door bracket in the same way, using the
•Figure 2:
Outer Trolley
Ring
Fastener
Door
Bracket
Clevis Pin
Clevis Pin 5/16"x1"
Straight
Door Arm
Curved
Door Arm
– Bring arm sections together. Find two pairs of holes that line up and join sections. Select holes as far apart as possible to increase door arm rigidity.
• Figure 3, Hole alignment alternative:
Figure 1
– If holes in curved arm are above holes in straight arm, disconnect straight arm. Cut about 6" from the solid end. Reconnect to trolley with cut end down as shown.
– Bring arm sections together.
– Find two pairs of holes that line up and join with bolts, lock washers and nuts.
• Proceed to Adjustment Step 1, page 20. Trolley will
Figure 2
HARDWARE SHOWN ACTUAL SIZE
Nut
Lock Washers 5/16"
Nuts
Door Bracket
Emergency
Release
Handle
Bolts
|
|
|
| Clevis Pin |
| Hex Bolt |
|
|
|
|
| ||
Clevis Pin |
|
|
| |||
| ||||||
5/16"x1" (Trolley) |
|
|
|
Figure 3
Lock Washers 5/16"
Nuts
Bolts
Cut This End
19