MOUNTING AND WIRING THE SAFETY REVERSING | Figure 5 |
SENSORS |
|
• Slide a | Wing Nut |
each sensor. Use wing nuts to fasten sensors to |
|
brackets, with lenses pointing toward each other across |
|
the door. Be sure the lens is not obstructed by a bracket |
|
extension (Figure 5). | Carriage Bolt |
• Finger tighten the wing nuts. | |
Lens |
•Run the wires from both sensors to the opener. Use
| insulated staples to secure wire to wall and ceiling. | TROUBLESHOOTING THE SAFETY REVERSING | |||
• Strip 7/16" (11 mm) of insulation from each set of wires. | |||||
SENSORS |
| ||||
| Separate white and white/black wires sufficiently to | 1. If the sending eye indicator light does not glow steadily | |||
| connect to the opener | ||||
| after installation, check for: |
| |||
| like colored wires together. Insert wires into |
| |||
| • Electric power to the opener. |
| |||
|
| ||||
| • A short in the white or white/black wires. These can | ||||
| grey (Figure 6). |
| |||
ALIGNING THE SAFETY REVERSING SENSORS | occur at staples, or at opener connections. | ||||
• Incorrect wiring between sensors and opener. | |||||
• | Plug in the opener. The indicator lights in both the | ||||
• A broken wire. |
| ||||
| sending and receiving eyes will glow steadily if wiring |
| |||
| 2. If the sending eye indicator light glows steadily but the | ||||
| connections and alignment are correct. | ||||
| receiving eye indicator light does not: | ||||
The sending eye amber indicator light will glow regardless | |||||
• Check alignment. |
| ||||
of alignment or obstruction. If the green indicator light in |
| ||||
|
| ||||
the receiving eye is off, dim, or flickering (and the invisible | • Check for an open wire to the receiving eye. | ||||
light beam path is not obstructed), alignment is required. | 3. If the receiving eye indicator light is dim, realign either | ||||
|
|
| |||
• | Loosen the sending eye wing nut and readjust, aiming | sensor. |
| ||
| directly at the receiving eye. Lock in place. | NOTE: When the invisible beam path is obstructed or | |||
• | Loosen the receiving eye wing nut and adjust sensor | misaligned while the door is closing, the door will reverse. | |||
| until it receives the sender’s beam. When the green | If the door is already open, it will not close. The opener | |||
| indicator light glows steadily, tighten the wing nut. | lights will blink 10 times. See page 16. | |||
|
|
| Connect Wire to |
| |
Figure 6 |
| Opener |
| ||
|
|
| |||
| Bell Wire | Finished |
|
| |
| Ceiling |
|
| ||
|
|
|
| ||
|
|
| 1. | Strip wire 7/16" | |
|
| Bell Wire | (11 mm) | ||
|
|
|
| 7/16" (11 mm) | |
|
|
| 2. | Twist like colored | |
|
|
|
| wires together | |
|
|
| 3. To insert or release | ||
|
|
|
| wire, push in tab with | |
|
|
|
| screwdriver tip |
| Red White Grey |
Safety Reversing Sensor |
| Invisible Light Beam |
Safety Reversing Sensor | Protection Area |
|
18