![](/images/backgrounds/52337/52337-7229x1.png)
ï Manually operate door. If it is unbalanced or |
binding, call a trained door systems technician. |
ï Check to be sure door opens & closes fully. Adjust |
WARNING
To prevent possible SERIOUS INJURY or DEATH:
•NEVER allow small children near batteries.
•If battery is swallowed, immediately notify doctor.
limits and/or force if necessary. (See pages 24 |
and 25) |
ï Repeat the safety reverse test. Make any |
necessary adjustments. (See Adjustment Step 3) |
ïOil door rollers, bearings and hinges. The opener does not require additional lubrication. Do not grease the door tracks.
The lithium battery should produce power for up to
5 years. To replace battery, use the visor clip or screwdriver blade to pry open the case as shown. Insert battery positive side up (+).
Dispose of old battery properly.
Battery positive
side up (+)
1.The opener doesn't operate from either the Door Control or the remote control:
ïDoes the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box or the circuit breaker. (Some outlets are controlled by a wall switch.)
ïHave you disabled all door locks? Review installation instruction warnings on page 7.
ïIs there a
ïThe garage door spring may be broken. Have it replaced.
2.Opener operates from the remote, but not from the Door Control:ïIs the door control lit? If not, reverse the wires. If the opener runs, check for a faulty wire connection at the door control, a short under the staples, or a broken wire.
ïAre the wiring connections correct? Review
Installation Step 6, page 14.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired operation.
3.The door operates from the Door Control, but not from the remote control:ïIs the door push bar flashing? If your model has the Lock feature, make sure it is off.
ïProgram the opener to match the remote control code. (Refer to instructions on the motor unit panel.) Repeat with all remotes.
4. The remote control has short range:ïChange the location of the remote control in your car.
ïCheck to be sure the antenna on the side or back panel of motor unit extends fully downward.
ïSome installations may have shorter range due to a metal door, foil backed insulation, or metal garage siding.
5.Opener noise is disturbing in living quarters of home:ïIf operational noise is a problem because of proximity of the opener to the living quarters, the Vibration Isolator Kit 89LMC can be installed. This kit was designed to minimize vibration to the house and is easy to install.
29