WARNING
To prevent possible SERIOUS INJURY or DEATH from electrocution:
• Be sure power is NOT connected BEFORE installing the receiver.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
MOUNTING RECEIVER
•Unplug the opener before proceeding.
•Fully extend antenna wire below bottom of case as shown.
•The receiver can be mounted directly on the door opener with the clips provided (Figure 1).
OR
•Attached to a ceiling/inside wall of the garage with connecting bell wire (not provided). Fasten the receiver to the ceiling or inside garage wall with dry wall screws provided (Figure 2).
NOTE: Transformer Model 85 or 95 is required if your residential garage door opener is a LiftMaster, Chamberlain or Sears.
INSTALLATION USING CLIPS
Loosen the three terminal screws on the receiver (labeled 1, 2 and 3) (Figure 1). Insert one end of a mounting clip under each terminal. Do not retighten at this time.
Loosen the three terminal screws on the opener used for push button controls and radio power.
Leaving the push button bell wire in place, insert the other ends of the mounting clips under the opener terminal screws.
NOTE: If the number sequence of opener terminals does not match the receiver, turn the receiver around (so back is facing out) and complete the connection.
Retighten the terminal screws on opener and receiver. Reconnect power to the opener. The receiver push bar should light. If it does not, use Transformer Model 85 or 95.
Universal Radio Control
OWNER’S MANUAL
Model 355LM Security✚® Receiver Only
Model 355-2LM Security✚®
(With 2 Remote Controls)
NOTICE TO U.S. CONSUMERS:
Some states prohibit the service or repair of garage door openers which cannot be made to comply with the safety standards contained in UL 325 (1988 revision). In order to comply with both the letter and the spirit of these laws, this universal radio control should not be used with any LiftMaster®, Chamberlain®, or Sears Craftsman® garage door opener manufactured prior to April 1, 1982. To find out if your
Figure 1
| Push Button |
Radio Power | Common |
Opener |
|
Terminals |
|
| ® |
Antenna Wire Fully Extended
Figure 2
Push Button
Radio Power | Common | |
Opener | ||
| ||
Terminals |
|
3 2 1
Antenna Wire
Fully Extended
INSTALLATION USING BELL WIRE
Attach one end of
Reconnect power to the opener. The receiver push bar should light. If it does not, use Transformer Model 85 or 95.
INSTALLATION WITH TRANSFORMER
With the transformer, use a
Figure 3
Opener Terminals
|
| 3 | 2 | 1 |
Transformer | 3 | 2 |
| 1 |
|
|
|
|
NOTE: Transformer Model 85 or 95 is required if your residential garage door opener is a LiftMaster, Chamberlain or Sears.