TO CHANGE AN EXISTING, KNOWN PIN
If the existing PIN is known, it may be changed by one person without using a ladder.
1.Press the four buttons for the present PIN, then press and hold the # button.
The opener light will blink twice. Release the # button.
2.Press the new
The motor unit lights will blink once when the PIN has been learned.
Test by pressing the new PIN, then press ENTER. The door should move.
INSTALLATION | Keyless |
| Entry |
1.Choose a convenient location for installation.
Install out of the reach of children at a minimum height of 5 feet (1.5 m), away from all moving parts of door.
For a
injury as the door swings up and out.
Typical
Installation
Exterior Front Wall
Door Jamb Edge (Optional)
Door Jamb Face
(SECTIONAL DOOR ONLY)
KEYLESS ENTRY MUST BE INSTALLED WITHIN SIGHT OF THE DOOR
TO SET A TEMPORARY PIN
You may authorize access by visitors or service people with a temporary
1.Press the four buttons for your personal entry PIN (not the last temporary PIN), then press and hold the ✽ button.
The opener light will blink three times. Release the button.
2.Press the temporary
ENTER.
The opener light will blink four times.
3.To set the number of hours this temporary PIN will work, press the number of hours (up to 255), then press ✽.
OR
3.To set the number of openings this temporary PIN will work, press the number of times to open (up to 255), then press #.
The opener light will blink once when the temporary PIN has been learned.
Test by pressing the four buttons for the temporary PIN, then press ENTER. The door should move. If the temporary PIN was set to a certain number of openings, remember that the test has used up one opening. To clear the temporary password, repeat steps
SPECIAL NOTE: The temporary password can ONLY be programmed to Keyless Entries working on a 315 MHz Chamberlain or LiftMaster Garage Door Opener. It WILL NOT work on Keyless Entries programmed to an external receiver.
The temporary password will continue to CLOSE the door even after the time has expired. To eliminate this, program a new temporary password into the Keyless Entry.
THE KEYLESS ENTRY BATTERY
WARNING
To prevent possible SERIOUS INJURY or DEATH:
•NEVER allow small children near batteries.
•If battery is swallowed, immediately notify doctor.
The battery should produce power | Top Cover | |
for at least one year. Replace when |
| |
the Keyless Entry illumination | Bottom | |
becomes dim or it doesn’t stay on | ||
Mounting Hole | ||
after a keystroke. |
| |
Dispose of old battery properly. | 9V Battery | |
| ||
| Battery Cover |
Test the reception of the Keyless Entry by operating your opener from the selected location. Change the location if necessary.
2.Remove the battery cover to access the bottom mounting hole. Slide the cover down to remove. Remove battery.
3.Center the keypad at eye level against the selected location. Mark
With cover open so bottom mounting hole is visible, Mark the position of the hole. Remove keypad and drill 1/8" (3.2 mm) pilot hole. Replace keypad and complete installation with bottom screw, using care to avoid cracking plastic housing. Do not over tighten.
Reinstall battery and replace the battery cover. To replace battery cover slide up and snap it into place.
KEYLESS ENTRY MOUNTING
(For reference only.)
(10.8 cm)
Replacement parts:
Keypad
FOR SERVICE, DIAL OUR TOLL FREE NUMBERS: U.S. 1-800-528-9131 and Canada 1-800-654-4736
| ©2006, The Chamberlain Group, Inc. |
114A3006D | All Rights Reserved |