FEATURES
For use with any 315 MHz SECURITY✚® garage door openers having a purple “learn” button.
Personalized Password: Up to 10,000 possible combinations. Password can be easily changed if desired.
Temporary Password: Can be added for visitors or service persons. This temporary password can be limited to a programmable number of hours or a programmable number of entries.
Rolling Code: While your password remains constant until you change it, the code between the Keyless Entry and the receiver changes with each use, randomly accessing over 100 billion new codes.
Operation: Opener activates when
If wrong numbers are accidentally pressed, correction can be made immediately. The ENTER button will transmit only the last four digits.
The keypad will blink for 15 seconds after the password is transmitted. During that time the ENTER button can be used to stop or reverse the door travel.
The Lock feature on openers with
One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been activated. This feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds. The keypad will blink twice when the one button close is active. The keypad will blink four times when one button close is deactivated.
USING THE MULTI-FUNCTION DOOR CONTROL
WARNINGTo prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and away from all moving parts of door.
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
SETTING THE PERSONAL ENTRY PASSWORD
We recommend that you install the battery and program the Keyless Entry now, prior to installation. Then you can test the reception at the mounting location before you proceed further.
USING THE “LEARN” BUTTON
LOCK
LIGHT
1. Enter a four digit personal identification number (PIN) of your choice on the keypad. Then press and hold ENTER.
2.While holding the ENTER button, press and hold the LIGHT button on the
3.Continue holding the ENTER and LIGHT buttons while you press the push bar on the
4.Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.
LOCK
LIGHT
LOCK
LIGHT
1. Press and release the “learn” button on motor unit. The learn indicator light will glow steadily for 30 seconds.
2.Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad. Then press and hold the ENTER button.
3.Release the button when the motor unit lights blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
Side two contains instructions for installing the Keyless Entry, changing the personal entry password and setting a temporary password.
1