®

The Safety Sensor Kit is compatible with Chamberlain® Gate Access Systems GA400D, GA420D, and GA200D. The Safety Sensors are designed to detect an obstacle in the path of the electronic beam and stop the gate operator.

CARTON INVENTORY

Verify carton inventory below.

Wire Nut (4)

Brackets

Safety Sensors

(Includes receiving and sending sensor)

 

Hex Head Bolt (2)

Wing Nut (2)

IMPORTANT INFORMATION ABOUT THE SAFETY SENSORS

When properly connected and aligned, the sensor will detect an obstacle in the path of its electronic beam.

The sensors must be installed so that the sending and receiving eyes face each other across the gate, no more than 24" (61 cm) above the ground. The sensors can be installed on the left or right of the gate as long as the sun never shines directly into the receiving eye lens.

The safety sensors must be securely fastened to a solid surface such as metal or a treated wood post (not provided). The light beam path must be unobstructed during normal operation of the gate.

NOTE: Due to the variety of gates and mounting applications, PVC conduit, wire, mounting hardware and posts are not provided. Refer to your local hardware store for additional hardware.

THE PROTECTOR SYSTEM®

SAFETY SENSORS MODEL 916GA

WARNING

To prevent SERIOUS INJURY or DEATH:

•Disconnect ALL electric and battery power BEFORE performing ANY service or maintenance.

•Correctly connect and align the safety sensors.

•Install the sensor so beam is NO HIGHER than 24" (61 cm) above ground.

•This product is for use with Chamberlain® GA400D, GA420D, and GA200D gate operators ONLY.

OPEN and ENTRAPMENT Safety Sensors

ENTRAPMENT

Safety Sensors

EntrapmentDanger

OPENSensors

Safety

APPLICATIONS
ENTRAPMENT SAFETY SENSORS

This will pause an opening gate until the obstruction has been removed. Upon removing the obstruction, the gate will continue to open. This will have no effect on the gate closing.

OPEN (PHOTO EYE/IR) SAFETY SENSORS

•GA400D/GA420D - This will pause an opening gate until the obstruction has been removed. Upon removing the obstruction, the gate will continue to open. This will have no effect on the gate closing.

•GA200D - This will stop a closing or opening gate, once the obstruction is removed the gate will continue to operate normally upon the next command given.

CLOSE (PHOTO EYE/IR) SAFETY SENSORS

•GA400D/GA420D - This will reverse a closing gate to the full open position (open limit). This will have no effect on a gate opening.

•GA200D - This will stop a closing or opening gate, once the obstruction is removed the gate will continue to operate normally upon the next command given.

CLOSE Safety Sensors

Property

Inside

CLOSESensors

Safety

1