Model 974LM Security✚ 4 Channel Remote Control
OWNER'S MANUAL
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote con- trol transmitters.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. Never permit anyone to cross path of moving gate or door.
NOTICE: To comply with FCC and or Industry Canada rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the bat- tery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The 974LM remote control can activate four separate residential or commercial garage door openers and/or gate openers. The instructions for programming garage door openers are illustrated below. Please refer to the original receiver programming for commercial and gate products.
All four push buttons work with Security✚ receivers having an orange “learn” button. The rolling code between these channels and the receiver changes with each use, randomly accessing over 100 billion new codes.
As an added feature, the 4th push button is capable of learning or being trained to duplicate or match another CGI manufactured fixed code or
Instructions are described and illustrated below.
When Several Remotes operate one device:
To match the 974LM to another CGI manufactured remote’s code (Remote Control X):
1
1.Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.
2.Within 30 seconds, press and hold the button on the
3.Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.
2
1 | 2 | 3 |
| KG | KG |
1. Begin by having both the 974LM and |
Remote Control X available. |
2. Press and hold the 1st and 4th push |
buttons on the 974LM until the yellow |
indicator light, visible on the bottom |
through a small hole, begins to blink. It |
will blink for 30 seconds; during this |
time it is in the learn or training mode, |
and the buttons can be released. |
3. While it is in learn mode, hold Remote |
Control X, another CGI fixed or billion- |
code transmitter, back to back with |
FCC labels touching as illustrated. |
4. Press and hold the Remote Control X |
push button as you slowly slide the |
remotes across each other until the |
974LM indicator light blinks very rapid- |
ly, indicating it has learned the code. (If |
Remote Control X is also a 974LM, you |
must press and hold its 4th push but- |
Yellow
Indicator
Light
FCC Label
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and the hold “learn” button on motor
unit until the learn indicator light goes out | 1 | 2 | 3 |
|
|
| |
(approximately 6 seconds). All previous |
|
|
|
codes are now erased. Reprogram each |
| KG | KG |
remote or keyless entry you wish to use.
ton.) |
5. The 4th button is now sending the |
same identical coded signal as Remote |
Control X. This code will remain inside |
the 974LM until replaced with another |
new code by repeating steps |
above, or by resetting to Security✚. |
Yellow
Indicator
Remote Light
Control X