Chamberlain PD432D 1/2 HP Carton Inventory

Carton Inventory

Your garage door opener is packaged in one carton which contains the motor unit and all parts illustrated below. Accessories will depend on the model purchased. If anything is missing, carefully check the packing material.

PARTS MAY BE STUCK IN THE FOAM. Hardware for assembly and installation is shown on the next page. Save the carton and packing material until installation and adjustment is complete.

LOCK

LIGHT

Multi-Function Door Control Panel

1-Button Remote Control (2)

Rail Support

	Braces (4)	Remote Control
	Braces (4)	Visor Clip
		Visor Clip

Sprocket

Coupling

Motor Unit with 2 Light Lenses

	2-Conductor Bell Wire
Rail Assembly	White & White/Red
Rail Assembly

	Trolley	Straight Door
	Trolley	Arm Section
		Arm Section

Header/Rail

Brackets

	LY
NT	ON
OU
G M
ILIN
CE
UP

Header Bracket

Hanging Brackets

The Protector System®

(2) Safety Reversing Sensors

(1 Sending Eye and 1 Receiving Eye) with attached 2-Conductor

White & White/Black Bell Wire

Curved Door

Arm Section

Door Bracket

Safety Labels

and

Literature

Safety Reversing Sensor

Mounting Bracket (2)

6

Contents

For Residential Use Only Introduction2-7 Assembly Installation11-26 Adjustment27-29 Operation30-34 Preparing your garage door Tools needed Planning Planning (Continued) Carton Inventory Hardware Inventory Assemble the Rail Assemble the Rail (continued) Fasten the Rail to the Motor Unit and Install the Trolley Attach the Rail Brackets Determine the Header Bracket Location Install the Header Bracket Attach the Rail to the Header Bracket Install The Protector System® INSTALLING THE BRACKETS Garage door track installation (preferred): Wall installation (Figure 2 & 3): Floor installation (Figure 4): MOUNTING AND WIRING THE SAFETY SENSORS Recommended Wire Routing Position the Opener Hang the Opener Install the Door Control Install the Lights Attach the Emergency Release Rope and Handle Electrical Requirements Complete the Safety Reversing Sensor Installation Fasten the Door Bracket ONE-PIECEDOORS Metal Doors: Connect Door Arm to Trolley ALL ONE-PIECEDOORS 1. Assemble the door arm, Figure 4: 2. Adjustment procedures, Figure 5: • Open door adjustment: decrease UP travel limit 3. Connect the door arm to the trolley: Adjust the UP and DOWN Travel Limits Adjust the Force Test the Safety Reversal System Test The Protector System® Using Your Garage Door Opener Using the Wall-MountedDoor Control To Open the Door Manually CARE OF YOUR OPENER LIMIT AND FORCE ADJUSTMENTS: THE REMOTE CONTROL BATTERY Repeat the safety reverse test (Adjustment Step 3, page 29) after HAVING A PROBLEM My door will not close and the light bulbs blink on my motor unit: 2.My remotes will not activate the door: My door reverses for no apparent reason: 5.My lights will not turn off when door is open: 1 FLASH 2 FLASHES 3 FLASHES 4 FLASHES 5 FLASHES To Add or Reprogram a Hand-heldRemote Control To Erase All Codes From Motor Unit Memory *3-ButtonRemotes To Add, Reprogram or Change a Keyless Entry PIN Rail Assembly Parts Motor Unit Assembly Parts ACCESSORIES 953D 3-ButtonSecurity✚® Remote Control: 935CB Motion Detecting Control Panel: 940D CHAMBERLAIN® ONE YEAR LIMITED WARRANTY 6 YEAR MOTOR LIMITED WARRANTY