CAUTION

 

 

 

 

To prevent possible OVERHEATING of the endpanel or

 

 

 

 

 

 

 

 

light socket:

 

 

INSTALLING THE LIGHT BULB(S)

 

• DO NOT use short neck or specialty light bulbs.

 

 

 

 

• DO NOT use halogen bulbs. Use ONLY incandescent.

 

 

 

 

To prevent damage to the opener:

 

 

 

 

• DO NOT use bulbs larger than 100W.

 

 

 

 

• ONLY use A19 size bulbs.

 

1 Flex Sides of Light Lens to

 

 

 

 

2 Rotate Light Lens Down

3 Install Standard Light Bulb(s)

 

Remove Lens from Tabs

 

 

 

(100W max) into Socket(s)

100 Watt (Max)

Standard Light Bulb

ELECTRICAL REQUIREMENTS

1 Plug Motor Unit into Power Outlet

RIGHTWRONG

WARNING

To prevent possible SERIOUS INJURY or DEATH from electrocution or fire:

•Be sure power is NOT connected to the opener, and disconnect power to circuit BEFORE removing cover to establish permanent wiring connection.

•Garage door installation and wiring MUST be in compliance with ALL local electrical and building codes.

•NEVER use an extension cord, 2-wire adapter, or change plug in ANY way to make it fit outlet. Be sure the opener is grounded.

NOTE: Plug motor unit into grounded power outlet. If a grounded outlet is not available, contact a qualified electrician to install a proper outlet.

OR

If permanent wiring is required by your local code, follow procedure below. Disconnect power to the circuit before removing cover to establish permanent wiring connections.

1 Remove Motor Unit

2 Remove Power

3 Run Wire from

4 Replace Motor Unit

Screws and Cover

Cord

 

 

Outlet to Motor Unit

Cover and Screws

 

 

 

 

Ground

 

 

 

 

Green

Tab

 

 

 

 

 

 

 

Ground Wire

Black

Ground

Black

 

 

Screw

 

 

 

Wire

Wire

 

 

 

 

 

 

 

 

 

Ground

 

 

 

 

 

Wire

 

 

White Wire

White Wire

Black Wire

16