Model ID850
Mounting screws (4)
Installation:
Use the included template to mark and cut an 9.5” hole in drywall away from ceiling joists.
We recommend wiring with AWG 16 or larger, stranded wire.
For proper phasing, both voice coils must be wired alike. Connect red wires to red terminals on speaker and to red or plus terminals on amplifier.
Install ID850 in hole. Tighten the mounting screws. The mounting dog ears will rotate outward and grip the drywall.
Aim tweeters
To control the volume of the speaker locally, use an impedance matching volume control, such as the Channel Vision VC302.
Features:
Dual voice coil speaker delivers stereo sound from a single speaker
Use when only one speaker will fit or to balance coverage in a whole house audio system
Use in bathrooms, hallways, entry ways
8”
Dual ½"
Tweeters swivel independently up to 45 degrees
Tweeter protection using thermal sensing polymer switches
18 dB/octave crossover network
Mounting template and paint shield included
Recommended power: 5W to 100W
Specifications:
Frequency range: | 55Hz - 20kHz ± 3dB |
Sensitivity: | 90dB |
Power Handling: | 75 Watts RMS (106 Watts Peak) |
Drivers: | 2- ½” Mylar dome tweeter |
| 1- 8” polypropylene woofer |
Impedance: | 8 ohms |
Finish: | ABS plastic |
Dimensions: | 10¾” OD. 4” height |
| (from surface of wall board) |
Weight: | 5 Lbs as shipped |
| Specifications subject to change without notice. |
2 | 3 |