Char-Broil 463248208 manual Attach bezel, Holes on fascia to Attach valve bracket

9	A)	Insert the Electronic Ignition module into the hole of left fascia, secure with the plastic nut.
	B)	Insert AA battery into ignitor module, negative (—) end first, screw on the ignition button.
	.C)	Connect main burner ignitor wire to the terminal on backside of electronic ignition module. Connect one end of
		side burner ignitor wire to side burner electrode and other end to the back of electronic ignition module.

A

		B
C	Side Burner Electrode
	Main Burner Wire		Some components are not
			shown for the clarity of
			illustration

Side Burner Wire

10 First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Install bezel with “OFF” at top.

				Note: Use upper and lower
Screws and Washers	Note: Use left and right			holes on fascia to
				attach bezel
removed from valve bracket	holes on fascia to
	attach valve bracket
		Control knob	#8-32x3/8” screw
				4mm
				lock washer

Control knob

bezel

Sideburner fascia

Sideburner valve bracket

Valve stem

20 • 463248208