11
20
12 Inside of cart, insert rear tabs(w/o holes) of tank heat shield into slots on the bottom of upper back panel, shown A.
Attach front tabs(w/holes) of tank heat shield under front brace using two #8x3/8” self-tapping screws, shown B.
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module.Total (4) connections.
Connect the two wires[(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Total (2) connections, shown A.
ignition module
Electronic
Left side panel
AB
B
C
Unscrew the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left side panel with
the nut, shown B.
Insert AA battery into ignition module, negative (-) end first. Then put on the cap, shown C.
Nut
-
+
AA batteryCap
4
(a)
(b)
Front brace
Tank heat shield
#8x3/8” self-tapping
screw
3
1
2
A
Tank heat shield