Chariot Carriers Cavalier manual Check attachment of all wheels, Front wheel

Fig. 28

Check attachment of all wheels.

This jogging stroller is equipped with quick release wheel retention mechanisms. The quick release allows the wheel to be installed and removed without tools. For proper and safe performance, read and follow these instructions carefully:

1. Check all wheels of your jogging stroller before every use.

OPEN

CLOSED

				D
			E
		S
	O
L
C

OPEN

OPEN

OPEN

OPEN

N

E

P

O

Fig. 24 Fig. 25 Fig. 26 Fig. 27

Front wheel

2.For the front wheel, move the quick release lever to the OPEN position and set the wheel so it firmly touches the inside of the fork ends.

3.With the lever about halfway between the OPEN position and the CLOSED position (Fig. 24), tighten the quick release adjusting nut on the opposite end of the quick release axle until finger-tight (Fig. 25).

4.Place the quick release lever in the palm of your hand and

move the lever in a motion as shown in Figure 26. Move the lever into the CLOSED position (Fig. 28). At the halfway closed position of the quick release lever, you should start to feel some resistance to this motion.

5.If the lever is moved to the CLOSED position with little or no resistance, clamping strength is insufficient. Simply return the

lever to the OPEN position, tighten the quick release adjusting nut further and close the lever, testing again for resistance. When the quick release device is properly tightened, and clamped to the closed position, the clamping force is adequate to cause metal

into metal engagement (embossing) of the fork surfaces.

•Do not tighten the quick release by using the quick release lever like a wing nut (Fig. 27). This will not result in sufficient force to hold the wheel in place.

6.Orient the quick release lever so that it does not interfere with any other stroller part and so that it will not become accidentally snagged by obstacles in the path of the jogging stroller (Fig. 28).

Hub axle

Fig. 29

Rear wheel

7.Insert the rear hub axle (Fig. 29) into the axle tube (Fig. 30) until the locking clip engages. You should hear a click as this happens, and the clip spring should sit against the axle tube.

16