FERRORESONANT BATTERY CHARGERS

C-CHARGER®AE SERIES

MANUAL FLOAT/EQUALIZE BATTERY CHARGERS

Safe to say, there’s no other float charger built like a C-Charger from Charles Industries. Rugged #304 grade stainless steel forms the sturdy housing that withstands virtually all environmental challenges; including heat, humidity, vibration, and other stress factors. The steel cover is hinged to ease installation

Electrically, the C-Charger is a paragon of efficiency and simplicity. It uses a ferroresonant transformer with integral self- regulation. It has been intelligently designed to be completely devoid of any complicated switching circuits that could possibly burn out. There are no tubes nor delicate electronics to fail or to cause radio frequency interference (RFI). By simplifying our design, Charles has increased reliability

without sacrificing performance or usability.

Voltage output to the batteries remains at a safe and constant DC level from full load to no load, even if AC power runs as high as 132 VAC or as low as 108 VAC. This automatic voltage regulation relieves strain on internal electrical components and lengthens the lifespan of the unit. All components are designed to operate safely and continuously in an ambient temperature as high as 122º F.

AE Series Battery Chargers are available in 12, 24 and 32 Volt models and may be used with

both lead acid and nickel cadmium battery banks.

Features

UL Listed

Cannot discharge battery during

• Isolated output: no direct AC to

• DC ammeter and voltmeter

 

AC failure

DC connection

Float/equalize switch

Stainless steel for corrosion

• Isolated positive and negative:

Equalize light

 

resistance

can be used as a negative

AC circuit breaker

Ferroresonant transformer for

voltage charger

Terminal board

 

reliability

• Two year limited warranty

 

 

Sealed silicon diodes

 

Page 1
Image 1
Charles Bentley & Son AE Series manual Chargerae Series Manual FLOAT/EQUALIZE Battery Chargers, Features