Charles Bentley & Son CI Series manual Chargerci Series SINGLE-RATE Float Battery Chargers

FERRORESONANT BATTERY CHARGERS

C-CHARGER®CI SERIES™

SINGLE-RATE FLOAT BATTERY CHARGERS

Safe to say, there’s no other float charger built like a C-Charger from Charles Industries. Rugged #304 grade stainless steel forms the sturdy housing that withstands virtually all environmental challenges; including heat, humidity, vibration, and other stress factors. The steel cover is hinged to ease installation.

Electrically, the C-Charger is a paragon of efficiency and simplicity. It uses a ferroresonant transformer with integral self-regulation. It has been intelligently designed to be completely devoid of any complicated switching circuits that could possibly burn out. There are no tubes nor delicate electronics to fail or to cause radio frequency interference (RFI). By simplifying our design, Charles has

increased reliability without sacrificing performance or usability.

Voltage output to the batteries remains at a safe and constant DC level from full load to no load, even if AC power runs as high as 132 VAC or as low as 108 VAC. This automatic voltage regulation relieves strain on internal electrical components and lengthens the lifespan of the unit. All components are designed to operate safely and continuously in an ambient temperature as high as 122º F.

CI Series Battery Chargers are available in 12, 24 and 32 Volt models and may be used with both lead acid and nickel cadmium batery banks.

Features

•	UL Listed	• Stainless steel for corrosion	• Isolated positive and negative:
•	DC ammeter	resistance	can be used as a negative
•	Terminal board	• Ferroresonant transformer for	voltage charger
•	Sealed silicon diodes	reliability	• Two year limited warranty
• Cannot discharge battery during		• Isolated output: no direct AC to
	AC failure	DC connection