Also check all joints and seals. On
completion of the installation and
commissioning please leave the
operating instructions with the
customer and advise them on the use
of the appliance.
kept to aminimum and should not be
morethan 125mm (5 inches) long.
The sealing face of the flue collar
must be coated with fire cement
beforefixing to the body of the stove
using the two screws provided. The
blanking plate must be removed,
sealed with fire cement and refitted,
carebeing taken to ensure that the
fold on the clamping plate is in line
with the lugs on the firebox as shown
in Fig. 7. Ensure that the clamping
plate does not prevent the throat plate
from seating correctly. All flue
connections must be well sealed.
SOOT DOORS
It is possible to pass a16 inch
diameter sweeps brush through the
appliance but in most back outlet
installations it will be necessaryto
have asoot door to enable the
chimney to be swept. The optional
vertical rear flue connector does
allow the chimney to be swept
through the stove.
Soot doors mayeither be in the actual
brickwork of the chimney or in the
register plate. Various positions of
soot doors are shown in Figs. 3to 6.
PRE LIGHTINGCHECK
Ensure that the throat plate is fitted
in the roof of the appliance. The
location and positioning of the throat
plate is shown in Fig. 2.
Check that the front fence is fitted
correctlyand that the door closes
properly.
COMMISSIONING
On completion of the installation
allow asuitable period of time for the
firecement and mortar to dry out
beforelighting the fire. If no grate is
fitted make alayer of ash or sand on
the base of the stove beforelighting.
Check to ensure that smoke and
fumes are taken from the appliance
up the chimney and emitted safely.
Page 7
Country 4 7/98 b