Chauvet 324 manual DMX Linking, Mounting, Replacing the, Fuse, DMX Connection, Master/Slave

EN		STRIKE 324 QRG
Replacing the	1.	Disconnect this product from power.
Fuse	2.	Using a Flat head screwdriver, unscrew the fuse holder cap from the
		housing.
	3.	Remove blown fuse and replace with a good fuse of the same type
		and rating.
	4.	Screw the fuse holder cap back in place and reconnect power.

DMX Linking	The STRIKE 324 will work with a DMX controller using a regular DMX serial
	connection. A DMX Primer is available from www.chauvetpro.com.
DMX Connection	The STRIKE 324 uses a regular DMX data connection for its DMX
	personalities: 1 Ch, 5 Ch, 8 Ch, and 12 Ch. See the User Manual to connect
	and configure for DMX operation.
Master/Slave	The STRIKE 324 uses the DMX data connection for its Master/Slave mode.
Connection	See the User Manual to connect and configure for master/slave operation.
Mounting
		Clamp
		(Model #CLP-15)
		Safety Cable
	(Model #CH-05)

Product

Mounting

Diagram

Floor Mounting

Secure the safety cable using the passageway on the back of the product.

Overhead Mounting

3