Chauvet 360Z-LED 3. Setup

Setup

-6- Q-Wash 360Z-LED User Man ual Rev. 01g

3. Setup

voltage range of 100~240 VAC, 50/60 Hz.

Make sure that you are connecting this product to the proper voltage, as per the

specifications in this guide, the product’s user manual, or on the product’s sticker.

Always connect this product to a protected circuit with an appropriate electrical

ground to avoid the risk of electrocution or fire.

To determine the power requirements for the Q-Wash 360Z-LED see the label affixed to

the side of the fixture. Alternatively, you may refer to the Technical Specifications chart i n

the Technical Information chapter of this manual.

The listed current rating indicates the maximum current draw during normal operation. For

more information, you may download the “Sizing the Circuit Breakers” document from the

CHAUVET® Web site.

Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if

the rheostat or dimmer channel serves only as a 0 to 100% switch.

The Q-Wash 360Z-LED comes with a power input cord terminated with an IEC connector

on one end an Edison plug on the other end (US market). If the power input cord that came

with your product has no plug or you need to change the Edison plug, use the table below

to wire the new plug.

Connection Wire (US) Wire (Europe) Screw Color (US)

AC Live Black Brown Yellow or Brass

AC Neutral White Blue Silver

AC Ground Green/Yellow Green/Yellow Green

Make sure to disconnect the fixture’s power cord before replacing a blown fuse, and

always replace it with a fuse of the same type and rating.

its housing.

2) Remove the blown fuse from its holder and replace it with a fuse of the exact same

type and rating (T 5 A, 250 V).

2) Insert the fuse holder back in its place, and reconnect power.

The fuse is locat ed

inside this com partment.

Remove it using a flat

head screwdriver.